Graticule: This method allows you to make a quick, visual estimate and take a simple measurement through the graticule divisions and the scale factor. For example, you can take simple measurements by counting the major and minor graticule divisions involved and multiplying by the scale factor. If you counted 6 major vertical graticule divisions between the minimum and maximum values of a waveform and knew you had a scale factor of 50mV/division, you could easily calculate your peak-to-peak voltage as follows: 6 divisions x 50mV/division = 300mV.
Cursor measurement The cursor measurement has two parallel lines on the screen, and move two lines to measure the time and voltage parameters of the input signal. The result of cursor measurement will be displayed on the second page of the cursor menu. Before use cursor measurement, make sure that the measured source is the signal you need to measure. Press Menu button to enter, and select Cursor to enter cursor measurement. Cursor Measurement Menu Table Enable On Off Open the cursor measurement. Close the cursor measurement. Voltage Time The horizontal line is shown to measure the voltage parameters. The vertical line is shown to measure the time parameters.
Type Source CH1 CH2 Select the measured source. Cursor1 Select Cursor1 and press up, down, left and right keys to move the Cursor1 position, and display the Cursor1 value. Cursor2 Select Cursor2 and press up, down, left and right keys to move the Cursor2 position, and display the Cursor2 value. Increment The difference between the Cursor1 and the Cursor2. To do cursor measurement, follow these steps: 1. Press F1 to open the cursor measurement; 2. Press F2 to select a type of cursor measurement. 3. Press F3 to select the channel that needs to be measured. 4.
Press F4 to enter the second page, press F1 or F2 to select Cursor1 or Cursor2, press up, down, left and right to move Cursor1 or Cursor1; 5. The result of cursor measurement will be displayed on the cursor menu. Automatic Measurement The oscilloscope provides 2 kinds of automatic measurements, including frequency and amplitude. Press Menu button to enter, select Measure to enter automatic measurement. Press F1 16 Menu Setting Description