keys to adjust the frequency, press F3 button to open the digital keyboard again, use the up, down, left, right direction keys and "Enter" key to set frequency parameter, select "OK" and press "Enter" button to confirm. 4. Set offset Press F4 button to enter the second page. Press F2 to select Offset , then use the up, down, left and right direction keys to adjust the frequency, press F2 button to open the digital keyboard again, use the up, down, left, right direction keys and "Enter" key to set frequency parameter, select "OK" and press "Enter" button to confirm. 5. Set duty cycle enter the second page.
Press F3 to select Duty , then use the up, down, left and right direction keys to adjust the frequency, press F3 button to open the digital keyboard again, use the up, down, left, right direction keys and "Enter" key to set frequency parameter, select "OK" and press "Enter" button to confirm. 6. Generate an arbitrary waveform It is necessary to edit the arbitrary waveform in connection with the software and download it into the machine. There are 4 arbitrary wave positions, and each position can permanently store an arbitrary wave. 7. After setting the waveform parameters, press the button to turn on or off the signal output.
The output waveform of the signal generator can be observed through an oscilloscope. Output the sine waveform Output a sine waveform with 10KHz/2.5Vpp as follows: 1. Press AWG button to enter the waveform generator function interface. 2. Press F1 to select “Sine”; 3. Frequency: First press F2 button to select Frequency , then use the up, down, left and right direction keys to adjust the frequency. Second press F2 button to open the digital keyboard again, use the up, down, left, right direction keys and "Enter" key to set frequency parameter, select "OK" and press "Enter" button to confirm. Set the frequency to 10KHz; 4. Amplitude:
First press F3 button to select Amplitude , then use the up, down, left and right direction keys to adjust the amplitude. Second press F3 button to open the digital keyboard again, use the up, down, left, right direction keys and "Enter" key to set amplitude parameter, select "OK" and press "Enter" button to confirm. Set the amplitude to 2.5V; 23