Tooling FACE PLATES 9- diameter face plates afe used for holding Irregular shaped pieces. Holes are drilled and tapped to permit the use of standard 1'\ x 18 bolts. The angle plate fastens directly to the T-slot of the ... face plate and is used to support work at right angle to .,. the face plate. Work clamping surface Is Ii· x 3-, JAW CHUCKS Rugged 5· capacity three Jaw and 5' four jaw chucks afe available. as shown at the right. for the Hardinge HlV-H lathe. These chucks are integrally mounted (or direct appli- cation to the precision taper nose spindle, thus eliminat- Ing a separate mounting plate.
FIXTURE PLATES The fixture plates are machined allover for direct application to the taper nose headstock spindle. Three sizes are available: 3' ,5' and Sf" diameter. The flange section Is f *thick. The centre hole ISiTw in diameter. These plates can be machined to become II fixture or for mounting fixtures to hold work or for mounting special purpose chucks. 19