2 Connectors and Pinouts System Components Connectors and Pinouts The diagram below shows the pinout for the camera’s IO connector. This would typically be used with the direct flying leads cable 61-9000151-01. The pinout for the digital I/O and power connector is as follows: To interface with this adapter cable connector, you can use either an Omron Microscan accessory cable or you can build your own. To build your own digital I/O and power cable, parts can be purchased from: Adapter Cable M12 12 Pin Plug – Power, I/O and Serial (61-9000132-01) The diagram below shows the pinout for the Adapter Cable supplied with each unit.
This adapter changes the pinouts so that all of the standard MicroHAWK, Vision HAWK, and QX Hawk accessories can be used. These include the power supply and interface cables as shown earlier in this chapter. HAWK MV-4000 Smart Camera Guide 2-19 Pin Signal Name 1 Output Common 2 Analog Output 3 Output 3 4 Power 5 Trigger 6 Input Common 7 Input 2 8 Input 3 9 Input 1 10 Output 1 11 Ground 12 Output 2 Cable Information Manufacturer Phoenix Contact GmbH and Co. KG Part Number SAC-12P- MS/3.0-PVC SC0 Order No: 1554788 Description Sensor/Actuator Cable, 12-Pos., Black PVC, Straight M12 SPEEDCON Plug on Free Conductor End, 3.0 m