Cycle Length Select one of the three cycle lengths by pressing the cycle length button. Each press of the cycle length button increases from a short cycle to a medium cycle or to a long cycle length. Pressing the cycle length button once more returns to the short cycle length. Table 2 should also be used as a general guideline for selecting cycle lengths for most models.There are some factors that cause the support removal process to take longer such as model geometry, small support filled crevices, small blind holes, or low water temperature coming into the system. Table 2: Cycle Length Settings Note:
When placing more than one model in the same cleaning cycle, use the combined build times of all the models to deter- mine the correct cycle length setting. Combined build time means the sum of the individual build times of each model put into the model basket. Start cycle When the proper cleaning tank level and cycle length are set, press the start cycle button. The system locks the lid and begins the process of filling the cleaning tank, heating the solution, and starts the cleaning of models inside the cleaning tank. After the initial cleaning of the models, the system drains and then refills with clean water for a final rinse and drain cycle.
When the cleaning cycle com- pletes, the left-hand progress LED will turn from yellow to green and the lid unlocks. 14 Combined Build Times Cycle Selection Approximate Cycle Times ≤ 4 hrs. Short 3 hrs. 4 to 12 hrs. Medium 6 hrs. > 12 hrs. Long 12 hrs.