Removal and Installation NOTE When the Ink Tubes System is replaced, to restart the Printer perform the following procedures. 1. Install the Setup Printheads (refer to the User’s Guide). 2. Connect the Power Cable and turn on the main Power Switch at the rear of the Printer. 3. The Front Panel warns that there are no Ink Cartridges installed. 4. Install the Ink Cartridges (refer to the User’s Guide for details). INK STARTUP 5. The Front Panel displays the message shown. 6. Wait about 60 seconds for the next instruction. Initializing Printer Please wait 60 sec 7. Remove the Setup Printheads from the Printhead Carriage. 8.
Install the Printheads and the Printhead Cleaners (refer to the User’s Guide for details). 8-31 HP DesignJet 5000 and 5500 Series Printers Service Manual