Tray 1 pickup and feed rollers CAUTION: When handling the rollers, avoid touching the roller surfaces. Skin oils and fingerprints on a roller surface can cause print-quality problems. The Tray 1 pickup and feed rollers are also user-replaceable components. 1. Open the front cover. 2. Remove one screw (callout 1) with a short screwdriver. Figure 2-25 Remove the Tray 1 pickup and feed rollers (1 of 4) 1 3. Push down on the roller-shaft bushing (callout 2) to release two alignment pins, and then slide the bushing to the left and off of the shaft to remove it. Figure 2-26 Remove the Tray 1 pickup and feed rollers (2 of 4) 2 82 Chapter 2 Removal and replacement ENWW