6 Parameter Table 26 I67E-EN V1000 Quick Start Guide Monitor Description Fault Trace U2-01 Current Fault U2-02 Previous Fault U2-03 Frequency Reference at Previous Fault U2-04 Output Frequency at Previous Fault U2-05 Output Current at Previous Fault U2-06 Motor Speed at Previous Fault U2-07 Output Voltage at Previous Fault U2-08 DC Bus Voltage at Previous Fault U2-09 Output Power at Previous Fault U2-10 Torque Reference at Previous Fault U2-11 Input Terminal Status at Previous Fault U2-12 Output Terminal Status at Previous Fault U2-13 Drive Operation Status at Previous Fault U2-14 Cumulative Operation Time at Previous Fault U2-15 Soft-Starter Speed Reference at Previous Fault U2-16 Motor q-Axis Current at Previous Fault U2-17 Motor d-Axis Current at Previous Fault Fault History U3-01 to U3-04 Lists the most recent fault that occurred through the fourth most recent fault.
U3-05 to U3-08 Accumulated operation time at the most recent fault through the fourth most recent fault. U3-09 to U3-14 Lists the fifth most recent fault that occurred through the tenth most recent fault. U3-15 to U3-20 Accumulated operation time at fifth most recent fault through the tenth most recent fault. * The following faults are not recorded in the error log: CPF00, 01, 02, 03, UV1, and UV2. DI/DO Sel.
Description Digital Input Function Selections 3 Multi-step speed reference 1 4 Multi-step speed reference 2 5 Multi-step speed reference 3 6 Jog frequency command (higher priority than multi-step speed reference) 7 Accel/decel time selection 1 F Not used (Set when a terminal is not used) 14 Fault reset (Reset when turned ON) 20 to 2F External fault; Input mode: N.O. contact / N.C. contact, Detection mode: Normal/ during operation Digital Output Function Selections 0 During Run (ON: run command is ON or voltage is being output) 1 Zero Speed 2 Speed Agree 6 Drive Ready E Fault F Not used 10 Minor fault (Alarm) (ON: Alarm displayed)