Chapter 20 Network Configuration and Data Exchange The COMMGR Driver has to be under Ethernet structure in the communication setting. Then, choose an Ethernet network from the graphic area and parameters can download to connected nodes. After the users click Download to PLC on the PLC menu, or on the toolbar, the Optional Download window will appear. Select the Routing Table checkbox in the Optional Download window, and click OK , the routing tables produced will be downloaded to the nodes connected to the Ethernet network.
Additional remark If the parameters related to an Ether Link or a PLC Link can be downloaded to the object selected, users can select the Ether Link checkbox or the PLC Link (Reset) checkbox in the Optional Download window. If a checkbox in the Optional Download window is gray, the checkbox cannot be selected. Please refer to the following sections for more information about Ether Links and PLC Links. Besides, the routing data stored in a PLC is data related to the PLC itself. The users cannot upload the routing data stored in a PLC. The system does not provide the function of uploading routing data.
20.2.8 Testing Routing After the routing tables produced are downloaded, users can test routing by means of a function provided by NWCONFIG. The steps of testing routing are as follows. (1) The users have to make sure that all the nodes are wired according to the configuration in NWCONFIG, and operate normally. The setting of the devices has to be consistent with the setting in NWOCNIFG. In the Select a Driver window, the users have to select the Routing Mode checkbox, and select a device in the First Station drop-down list box. 20-37