Chapter 23 Wizard Tool Icon toolbar description: In Axis Settings page, users can setup each axis control output. The number of axis shown varies according to the supported PLC types. When executing 2-axis interpolation movement, do NOT choose Pulse for Output instead choose Pulse/Dir or AB phase. Then click Enable next to the Output and input self-defined Value Setting and Unit Name as well as the Value Setting of Pulses for one motor rotation . The follow image shows that the setups of Axis 1 for 100 mm can output 1000 pulses in one motor rotation. Click Default Setting to restore the initial setup for the unit setting page.
In Upload Password Settings page, the passwords are set to protect during uploading for position planning table downloaded to the host. After typing in the Password and again for Confirmation, click OK and when successful, a hint indicating ‘password protection activated’ is shown below. To remove the password setting, input the Password in the box to click OK and when successful a hint indicating ‘password protection is not activated’ is shown below. 23-3 Icon Name Function Description Import Import *.pnt to the current position planning table. Export Export positioning table to *.pnt. Upload Read positioning table settings via hosts.
Download Positioning Write positioning table settings in hosts.