Chapter 3 PLC System Configuration & Settings 3.1.4.5 System Settings – Position Control Parameter The parameters on Position Control Parameter table set to specify input points as the positive and negative limits of axis 1~ axis 6 channels. 12 limit points can be set at most. Axis No. 1~6 can also be set as Z phase triggers, home function finish points and clear output selects or positive/negative limited position. Axis1 (Y0.0/Y0.1) Positive/negative Limited Select ~ Axis 6 (Y0.10/Y0.11) Positive/negative Limited Select. Select the rising or falling edge trigger and X input point on the drop-down list.
Axis1 (Y0.0/Y0.1) Z Phase Trigger ~ Axis6 (Y0.10/Y0.11) Z Phase Trigger Select the rising or falling edge trigger and X input point on the drop-down list. Axis1 (Y0.0/Y0.1) Home Function Finish and Clear Output Select ~ Axis6 (Y0.10/Y0.11) Home Function Finish and Clear Output Select Select the rising or falling edge trigger and X input point on the drop-down list. Axis1 (Y0.0/Y0.1) Positive/negative Limited Position ~ Axis6 (Y0.10/Y0.11) Positive/negative Limited Position Set up the number of pulses as the positive or negative limited position in axis 1~6; setting range is -2147483647 ～ 2147483647. 3-91