ISPSoft User Manual 3.1.4.16 Delta Device Parameters Backup and Restore ISPSoft V3.10 supports Delta device parameters backup and restore. The firmware of your AS PLC CPU should be V1.08.10 or higher and you need to use EIP Builder V1.70 or later to backup / restore Delta device parameters. Now ISPSoft V3.10 only supports Delta C2000 invertor for parameters backup and restoration. After you back up the parameters, with ISPSoft and EIP Builder, you can restore the parameters to your devices. Up to 32 Delta devices are supported. Refer to AS Series Operation Manual for further information. Steps to back up Delta device parameters to the SD card in the PLC device 1.
Open EIP Builder (refer to section 3.1.3.16) and complete the network planning. 2. Click CMC-EIP01 (Delta C2000) and click Parameter Backup / Restore tab. 3. Select a backup path and click Backup button to back up Delta C2000 parameters. The backup file is stored as the .par file. For multiple devices, the file name varies according to different station number for easier identification. 3-110