Recharge the Jump Starter A guide to Safety Indicator: The product comes partially charged and needs to be fully charged prior to use. Please charge your jump starter through the Type-C Input port once you receive it. EN Note: Only jump start vehicles when the battery level of the jump starter is more than 50%. Jump Start Vehicles (12V Only) A guide to LED Light: Important: Make sure you have turned off all of the power loads of the vehicle, including headlights, radio, air conditioner, etc., before attempting to jump start the vehicle. Step 1: Plug the blue end of jumper cable into the Jump Start Socket. Press the Power Button once to turn on the jump starter.
Press and hold the Power Button for 3 seconds to turn on the LED Light. Then press the Power Button once separately to toggle between Flashlight, Strobe, SOS and OFF in turn. 5 6 Solid green The Jump Starter is ready for use. Solid red Reverse polarity of battery clamps is detected. Flash green The battery level of the vehicle is too low. Press the "BOOST" Button and wait until the Safety Indicator becomes solid green. Then start your vehicle within 30 seconds. The indicator doesn't light up The battery of the vehicle may be totally dead. Make sure that you have correctly connected the clamps to the vehicle battery.
Then press the "BOOST" Button and wait until the Safety Indicator becomes solid green. And then start your vehicle within 30 seconds. Alternately flash red and green You have tried 4 jump starts within 10 minutes. Please disconnect the clamps and reconnect to try again.