JumpSurge2000 User Manual V2 (EN)

For Services and Support 86-755-21612590 1-833-629-4832 (North America) support@topdon.com www.topdon.com @TopdonOfficial @TopdonOfficial JUMPSURGE 2000 JUMP STARTER For 12 volt lead-acid batteries USER MANUAL

Стр. 1

Welcome Thank you for purchasing JUMPSURGE2000. If any issues arise during the use of this product, welcome to contact support@ topdon.com for official technical support. EN About JUMPSURGE2000 JUMPSURGE2000 serves as a portable Jump Starter that delivers 2,000 peak amps for jump starting a 12V lead-acid battery in seconds. It supports quick and safe starts for 12V cars, boats, motorcycles, ATVs, lawnmowers, caravans, tractors, trucks, etc., up to 8.0-liter gasoline or 6.0-liter diesel engines, with 40 times boost capability on a single charge. It can also be used as a power bank to quickly charge electronic devices like phones and tablets, or supply power to DC devices.

English Safety Cautions Please read this user manual carefully before use and keep it for future reference. 1. ONLY use the battery clamps that come with this product. 2. DO NOT use this product if the cable or the jump starter has any damage. 3. This product can be only used for starting vehicles with 12 volt lead-acid batteries. 4. Only jump start vehicles when the battery level of the jump starter is more than 50%. 2

Стр. 2

Product Overview 5. If the engine does not start successfully at the first try, disconnect the clamps from the vehicle battery and wait at least 20 seconds before reconnecting. DO NOT attempt more than 3 consecutive jump starts within 2 minutes. 6. DO NOT put the product under direct sunlight or at hot areas. 7. DO NOT disassemble the product by yourself. 8. DO NOT place the product in high temperature environment for a long time. The working temperature is -10°C~40°C (14°F~104°F). 9. Check the battery level of this product every two months and charge it regularly. 10. A Lithium-ion battery is included in the product. Please dispose of it under local regulations at the end of its life.

USB Output (5V/2A) USB Output (5/9/12V Quick Charge 3.0) EN Type-C Input (5V/3A 9V/2A) Jump Start Socket DC Output (Max 16.8V/10A) Battery Level Indicator Power Button What's Included LED Light Jump Starter Battery Clamp Type-C Cable User Manual EVA Bag Safety Indicator Negative Clamp (Black) Positive Clamp (Red) BOOST Button 3 4

Стр. 3

Recharge the Jump Starter A guide to Safety Indicator: The product comes partially charged and needs to be fully charged prior to use. Please charge your jump starter through the Type-C Input port once you receive it. EN Note: Only jump start vehicles when the battery level of the jump starter is more than 50%. Jump Start Vehicles (12V Only) A guide to LED Light: Important: Make sure you have turned off all of the power loads of the vehicle, including headlights, radio, air conditioner, etc., before attempting to jump start the vehicle. Step 1: Plug the blue end of jumper cable into the Jump Start Socket. Press the Power Button once to turn on the jump starter.

Press and hold the Power Button for 3 seconds to turn on the LED Light. Then press the Power Button once separately to toggle between Flashlight, Strobe, SOS and OFF in turn. 5 6 Solid green The Jump Starter is ready for use. Solid red Reverse polarity of battery clamps is detected. Flash green The battery level of the vehicle is too low. Press the "BOOST" Button and wait until the Safety Indicator becomes solid green. Then start your vehicle within 30 seconds. The indicator doesn't light up The battery of the vehicle may be totally dead. Make sure that you have correctly connected the clamps to the vehicle battery.

Then press the "BOOST" Button and wait until the Safety Indicator becomes solid green. And then start your vehicle within 30 seconds. Alternately flash red and green You have tried 4 jump starts within 10 minutes. Please disconnect the clamps and reconnect to try again.

Стр. 4