ADF Unit Figure 6-240 ADF Unit (shown without Optical Unit) Note To get to the Glass Plate assemblies, you can remove the ADF Unit with the Optical Unit intact. (An Optical Unit is not included with a replacement ADF Assembly.) 1 Remove 4 TP screws (m3x6) (callout 1) and unplug 3 cables from the Main Board Tray (shown in Figure 6-220 on page 526). WARNING! Once the ADF latch is removed, if the lever is triggered the ADF can spring open rapidly and pinch your fingers. CAUTION Be careful not to damage the LED Assembly (callout 2) when you are working around the ADF Unit. 2 Lift off the ADF Unit. To replace 1 The ADF is keyed to the Glass Plate Assembly.
Make sure it fits properly in its place before you replace the screws. C4265-90907 Copy Module ADF Unit Assemblies 547