LED Assembly PCA Figure 6-239 LED Assembly PCA 1 Remove the ADF Latch Cap (page 511) and the ADF Cover (page 512). 2 Remove 1 TP screw (m3x8) (callout 1). 3 Remove 1 TP screw (m3x8) from each of the 2 cable holders (callout 2) and remove the cables from the cable holders. CAUTION Do not attempt to unplug the connector from the PCA. It is permanently attached to the PCA on one end. Unplug the other end from the Main Board. 4 Unplug 1 connector from the Main Board. 5 Remove the cable (callout 3) from the wiring harness sleeve. To replace Note the PCA has 2 holes, one for the screw and one for the locating pin. Be sure to orient the PCA properly with the 2 holes.
546 Chapter 6 Removal and Replacement C4265-90907