Руководство по эксплуатации KPE-LE02 Digital Keypad для VFD-E Series (EN)

PLC2 mode active \ Installation Method 1. Direct installation (unit: mm[inch]) GO START Success to set parameter. Input data error Method 2. Mounting by the plate thickness (unit: mm[inch]) A. Thickness=1.2mm[0.05 inches] NOTE ： In the parameter setting mode, you can press to the selected mode. B. Thickness=2.0mm[0.08 inches] PLC1 mode active or Display Message Descriptions NOTE: In the selected mode, press to set the parameters. Displays “Err”, if the input is invalid.

[ How to Operate the Digital Keypad (When operation source is digital keypad) Setting Mode Setting parameters To change data Setting direction Setting PLC Mode START ‹ Please thoroughly read this instruction sheet before installation and putting it into use. ‹ The content of this instruction sheet and the driver file may be revised without prior notice. Please consult our distributors or download the most updated instruction version at http://www.delta.com.tw/industrialautomation.

X Description of the Digital Keypad Y Dimensions in mm [inch] KPE-LE02 Digital Keypad for VFD-E Series 5011666101-K201 8.1 [0.32] Z Display Messages Displays the actual output frequency at terminals U/T1, V/T2, and W/T3. Displays “End” for approximately 1 second if input has been accepted by pressing key. After a parameter value has been set, the new value is automatically stored in memory. To modify an entry, use the and 20071112 Displays the output current at terminals U/T1, V/T2, and W/T3. 52.4 [2.06] 8.6 [0.34] 61.0 [2.40] Displays the actual stored value of the selected parameter. Instruction Sheet Display Message Descriptions Displays the AC motor drive forward run status.

Displays the AC motor drive reverse run status. M3*0.5(2X) 34.3 [1.35] Displays the AC drive Master Frequency. User defined unit (where U = F x Pr.00.05) 1.5 [0.06] 16.3 [0.64] Displays the selected parameter. The counter value (C). 25.9 [1.02] External Fault. keys. 42.4 [1.67] 71.9 [2.83]

Стр. 1