L-4533A/L-4533AW/L-4033A/L-4033AW Operation Guide Introduction 22 Warning When connecting cables make sure the direction and order are correct. Fire or injury could occur. Only install in the locations shown in this guide. Only connect the equipment indicated. U “Press Parts” on page 14 When newly earthing the product, contact a qualified electrician to make the installation. Contact service support when moving this product. If the product falls over, an injury could occur. If cables and so on are damaged, electric shock or fire could occur. The product's condition could be altered and that may result in a decline in performance.
If the touch panel breaks, handle the liquid crystal with care. Provide first aid should the following occur. ❏ If any gets on your skin, wipe it off and wash the area thoroughly in soap and water. ❏ If any gets in your eye, flush the eye for at least 15 minutes and then consult your doctor. ❏ If any is swallowed, rinse your mouth well with clean water, drink a lot of water and induce vomiting, and then consult your doctor. ❏ Never place your hand and so on near the roller while the press is operating. Hands, hair, clothes, and so on may be caught in the roller.
❏ Before performing inspections and cleaning of the feed section, the drier section, or the rewinder section, switch to Motor Drive Off mode on the touch panel's Periodic Maintenance screen. If the nip lever is operated without switching to Motor Drive Off mode, the roller rotates and may catch hands, hair, clothes, or other things.