L-4733A/L-4733AW Operation Guide Safety Instructions and Notes on Usage Notes on Consumables 13 Caution Perform operations for the Rewinder and surrounding area after pressing the Wind Ready switch and confirming that the lamp is off. Cutting the substrate or operating the nip lever while the lamp is lit causes a sudden winding and may result in an injury. Be sure your AC power cord meets the relevant safety standards of the area where you plan to use it. Use only the type of power source indicated on the product’s label. Caution Do not disassemble ink cartridges. If it is disassembled, ink could get in your eyes or on your skin.
Except as explained in this manual, do not shake or swing the ink cartridge too vigorously; otherwise, the ink may leak. U “Replacing Ink Cartridges” on page 228 Do not store ink cartridges within the reach of children. If ink gets in the eyes or mouth, or stains the skin, treat the area as follows. ❏ If ink gets on your skin, wash the area immediately with soap and water. ❏ If ink gets in your eyes, flush them immediately with clean water. Congestion or light inflammation of the eyes may occur if they are not treated immediately. Consult your doctor at once if any anomalies occur. ❏ Consult your doctor at once if any ink gets in your mouth.
Do not rub the edges of the substrate with your hand. The edges of the substrate are thin and sharp and could cause an injury. When loading or removing roll substrate, be sure to secure appropriate personnel and appropriate transport equipment such as a lifter according to local laws on health and safety. You can install up to 100 kg of roll substrate (however, the maximum diameter is ø600 mm). Transporting, loading, or removing without following the instructions is extremely dangerous and could cause injuries such as trapping a hand or finger or dropping it on your foot. Be sure to adopt a sensible lifting posture whenever you lift the roll substrate.
If you do not use the correct posture, an injury could occur.