L-4733A/L-4733AW Operation Guide Safety Instructions and Notes on Usage Notes on Usage Notes on the Usage Environment ❏ We recommend using this product at a room temperature of 20 to 26˚C. ❏ You can use this product up to 2000 m above sea level. Do not use it at a higher altitude. ❏ Do not suddenly change the temperature in the room where this product is installed. If the temperature changes suddenly, drops of water (condensation) could occur inside the press which may have an adverse effect on operations. ❏ Make sure the work space is sufficiently ventilated and not closed. ❏ Do not place any containers containing water, such as vases or cups, on this product.
If water enters this product, the product may breakdown. Also, do not put any heavy objects on this product. ❏ This product has air intakes and exhaust outlets. Do not place film sheets or paper and so on over the vents on the product, and be sure to secure sufficient space around the product. If the product is not ventilated properly, ink may not dry sufficiently and the print output may be soiled. U “External dimensions and necessary space” on page 34 ❏ Do not use accessories designed for this product with any other products. Notes on Operating ❏ Note the following points when the press is operating. You may not be able to print.
❏ Do not cancel processing by turning OFF the breaker on the back of the press (except under normal conditions) Once the press is turned OFF , it takes about one minute for the press to start after it is turned back ON . ❏ Do not subject this product to strong vibrations. ❏ While the carriage is operating no covers open except the ink cartridge cover and the maintenance tank cover. ❏ When printing for 12 hours or more, shut down the press and perform Daily Maintenance and Startup Inspection. ❏ Use the touch panel to operate the application software installed in the press. This should only be used as the control panel for the press.
❏ Do not place anything weighing over 5 kg on the Workbench for the feeding unit or the Rewinder. Otherwise the rollers under the workbench may be forced out of their parallel positions. ❏ Unattended operations are not supported. Do not leave the press unattended while printing. Notes on Handling Ink Cartridges ❏ Do not disassemble or remodel ink cartridges. You may not be able to print. 14