L-6534VW Operation Guide Basic Operations O Set the following, and then press OK . P Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then the press automatically adjusts the sensor sensitivity. Q If the first copy pauses on the unwinder side workbench, check the print results. R On the Sensor Settings Complete screen, press Print . S On the screen displayed, enter Copies , and then press Print . Start printing. This completes this section. Note: If the print position shifts even after repeating the adjustment procedure, try the average for the adjustment values you calculated.
Adjusting the Print Position Using a Ruler Prepare the following in advance. ❏ Print data for printing ❏ Ruler for measuring A Select the preset for printing to match the substrate you are loading, and set it as the default preset. U “Creating and Editing Print Info.” on page 89 See the following pages for more information on creating presets and print information. U “Creating and Editing Preset for Printing” on page 91 B Make settings for performing reverse feed the substrate in the preset for reverse feeding, and set it as the default preset.
149 Item Set value Copies 1 Perform Eye Mark Verification Printing Select Item Set value Reverse Feeding Apply Eye Mark for Reverse Feeding Use Distance from Top Edge of Substrate Apply to print data