L-6534VW Operation Guide Various Print Settings (2) Enter "16.1 m" (at a print speed of 30 m/min) in Feeding Amount , and press Start feed . The input value for Feeding Amount varies depending on the selected print speed. U “Input Value for Feeding Amount of Substrate” on page 70 The leading eye mark stops at the cutting position on the unwinder side workbench. Press the Slow Feed or Slow Rev. Feed switch as necessary to align the leading eye mark with the cutting position. (3) Set the Feeding Amount to "0.7 m", and then press Start feed . The leading eye mark stops just before the eye mark sensor.
S From Adjust Eye Mark Sensor on the Loaded Substrate tab, adjust the sensitivity for eye mark detection and the eye mark sensor. U “Setting Eye Marks and Eye Mark Sensor” on page 125 T Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0. U Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then pause on the unwinder side workbench.
V Check the print results and measure the print shift in the surface and rear surface, and then enter the horizontal and vertical shift values in Adjust Print Position Horizontally and Adjust Print Position Vertically as the adjustment values. W Press Print . X On the screen displayed, enter the number of copies, and then press Print . Start rear surface printing. This completes this section. 192