HINT: Mark the RH and LH rack boots. gn 5. REMOVE RACK GUIDE SPRING CAP LOCK NUT (a) Using SST, remove the lock nut. SST: 09922-10010 NOTICE: Use SST 09922-10010 in the direction shown in the illustration. 6. REMOVE RACK GUIDE SPRING CAP 7. REMOVE RACK GUIDE SPRING AND RACK GUIDE SUB-ASSEMBLY 8. REMOVE DUST COVER 9. REMOVE CONTROL VALVE HOUSING WITH CONTROL VALVE ASSEMBLY (a) Place matchmarks on the valve housing and rack housing. (b) Remove the 2 bolts. (c) Pull out the control valve assembly with the valve housing. (d) Remove the O-ring from the valve housing. 10. REMOVE CONTROL VALVE ASSEMBLY (a) Using SST, loosen the bearing guide nut. SST:
09631-20060 (b) Wind vinyl tape to the control valve shaft. (c) Using a plastic hammer, tap out the valve assembly with the nut from the control valve housing. NOTICE: Be careful not to damage the oil seal lip. (d) Remove the nut from the valve assembly. NOTICE: Be careful not to damage the oil seal lip. (e) Remove the O-ring from the nut. 11. REMOVE CYLINDER END STOPPER AND SPACER (a) Using SST, remove the stopper. SST: 09922-10010 cardia