LVS-7500 External System Installation and Quick Start Guide 14. After the docking plate is correctly aligned with the printhead, gently pull out and turn the docking plate locking pin so that no part of the pin is visible. 15. Place the readhead on the docking plate by aligning the L-shaped slot on the readhead to the docking plate lip. Once aligned, slowly push down the readhead to fit firmly against the docking plate. Then, push the readhead forward, locking it in place. 16. After the readhead is locked securely to the docking plate, turn and then push in the locking pin. 17. Optional:
The tension on the roller is set correctly prior to shipment; thus, this step is needed only in rare cases when the roller tension needs adjusting (such as in cases due to changes in label stock thickness). To adjust the roller tension, turn the thumbscrews equally on both sides clockwise or counter-clockwise to find the ideal roller tension between the docking plate roller and the LVS-7500 External System readhead roller. The docking plate roller should touch the LVS- 7500 External System readhead roller and allow the labels to be “pinched” between the two rollers. LVS-7500 External System Installation and Quick Start Guide Page 36 of 45