STARTING AND DRIVING Caution! initial cruise speed is set as the current vehicle speed. At this time, the cruise speed value can be adjusted by pressing the acceleration/deceleration key. Only a Lynk & Co Center can repair CC, otherwise CC may not service properly. VESPER Note! Enable Cruise Control (CC) □ CC cannot be enabled when the cruise system is faulty. □ Putting CC in standby mode will not enable it. CC is only enable when the set key is pressed. □ When driving mode is in electric mode, the maximum cruise speed is set to 120 km/h.
By pressing the left/right selection key on the left keypad of the steering wheel to switch the drive assistance function to CC and the CC enters standby mode. Adjusting speed for Cruise Control (CC) When CC is in standby mode: ■ When the vehicle speed is lower than 30 km/h, the CC cannot be enabled. At this time, the cruise speed value cannot be adjusted by pressing the acceleration/deceleration key. ■ When the vehicle speed is higher than 30 km/h and lower than 150 km/h, press the setting key, and the CC is enabled. The Adjusting speed When the CC system is activated, different cruise speeds can be set 187