8. TURBOCHARGER (3) Thrust bearing installation 1) Fit thrust bushing on turbine shaft (1). 2) Apply lubricating oil on the bearing portion of thrust bearing (6) and install it in bearing housing (15). 3) Apply Locktite on the threaded portion of M3 Torx T machine screw (17) for thrust bearing installation, and use Torx torque driver for installation by tightening to the specified torque. Tightening torque: 1.3 ± 0.1 Nm {13 ± 1 kgcm} (4) Seal plate installation 1) Fit the seal ring on oil thrower (2). 2) Insert oil thrower (2) into seal plate (4). Note: The seal ring joint portion shall be positioned as illustrated at right.
3) Apply liquid gasket (Three Bond No.1207) on the seal plate mounting surface on the compressor side of bearing housing (15). Note: See the illustration below for the applying position. Applying thickness: 0.1 – 0.2 mm 4) Install seal plate (4) on bearing housing (15). 5) Apply Locktite on the threaded portion of M3 machine screw for seal plate mounting, and tighten it with a torque screwdriver. Tightening torque: 1.3 ± 0.1 Nm {13 ± 1 kgcm} 82E-5 – 98E-5 SERIES 8-17