en Control and display elements Control and display elements Overload protection To prevent serious damage to your appliance if the base attachment is overloaded, the agitator paddle has a notch (predetermined breaking point). If overloading occurs, the agitator paddle will break at this point. A new agitator paddle is available from Customer Service (No. 630701). Spare parts with a predetermined breaking point are not covered by our warranty obligations. MFW35... Button I Press button I to switch on the appliance. The drive will start up at once. Button O Press button O to switch off the appliance. The drive stops. MFW36.../MFW38... Button k Press button k to switch on the appliance.
The drive will start up at once. Press button k again to switch off the appliance. The drive stops. Replace agitator paddle X Fig. C 1. Release the screw in the agitator paddle with a screwdriver (PH2) and remove the faulty paddle. 2. Fit a new agitator paddle and screw tight rev button Press the rev button to start the reversing function. Release the rev button to stop the reversing function. X “Reversing function” see page 20 again. Reversing function ONLY MFW36.../MFW38... The reversing function is designed to release food that has got stuck by briefly running the worm gear in reverse. The reversing function switches off automatically after 15 seconds.
All models Operation indicator The operation indicator lights up when the appliance is switched on. On models with the reversing function the function indicator flashes for as long as the rev button is pressed. Caution! – – Never operate the appliance for any length of time in the reversing function. – – Never press the rev button while the appliance is switched on. Only press the rev button once the appliance has completely stopped. ■ ■ Switch the appliance off with button k and wait until the drive has stopped. ■ ■ Press the rev button briefly and wait until the drive has stopped. ■ ■ Switch the appliance on again with button k .
Release button Press the release button to unlock an attachment fitted on the appliance. Only when the release button is pressed is it possible to turn the attachment clockwise and remove it from the base unit. Cable storage compartment The mains cable can be pulled out of the cable storage compartment or pushed back in again. Only ever pull the cable out as much as is required. Note: If food that has got stuck is not released by briefly putting the appliance into reverse, switch the appliance off, unplug and clean it.
X “Care and daily cleaning” see page 23 Storage compartment Unused perforated discs belonging to the meat mincer can be kept in the storage compartment and it closed with the cover. 20 MFW3_EU_8001019358.indb 20 01.12.2015 12:05:48