Care & Maintenance Brush * Weekly cleaning is recommended. Side Brush * Monthly cleaning is recommended. 1. Flip the vacuum-mop over and pinch the clips to remove the brush cover. 2. Lift the brush out of the vacuum-mop, then clean the brush bearings. 3. Use the included cleaning tool to cut any tangled hairs on the brush, and remove the hairs and other debris from the brush. 4. Reinstall the brush and the brush cover, and ensure they are securely in place. 1. Flip the vacuum-mop over and remove the side brush upwards to clean it. 2. Reinstall the side brush to the vacuum-mop. Note: It is recommended to clean the side brush monthly and replace every 3 to 6 months.
Omnidirectional Wheel * Clean it as needed. Note: It is recommended to clean the brush weekly and replaced every 6 to 12 months. Brush Cover 1. Flip the vacuum-mop over and pull out the omnidirectional wheel. 2. Remove hair, dirt, and other debris from the wheel and axle. 3. Reinsert the wheel and press it firmly back into place. Wheel Clips Brush Axle Brush Bearings Notes: · A small screwdriver or other pry tool can be used to gently pop out and remove the wheel. · The wheel can be cleaned with water and reinstalled after drying. Cleaning Tool CAUTION: If too much hair is tangled in the brush, or if the hair is tightly tangled, do not forcibly pull on it, as this could damage the brush. 14