Routine Maintenance Cleaning the Washable Filter 3. Remove the filter as shown in the diagram, forcefully shake it to remove excess water, then place it aside to dry before reinstalling it. 1. Open the dust compartment cover at the positions marked with arrows. Note: Filter must be fully dry before use (allow at least 24 hours). Note: Biweekly cleaning is recommended. Omnidirectional Wheel 1. Flip the vacuum-mop over and pull out the omnidirectional wheel. 2. Remove hair, dirt, and other debris from the wheel and axle. 3. Reinsert the wheel and press it firmly back into place. 2.
Add clean water to the dust compartment, and close the dust compartment cover, then shake the compartment back and forth, finally pour out the water. Repeat these steps until the filter is clean. Note: Only clean water should be used to clean the filter. Do not use detergent. Do not atempt to clean the filter with a brush or finger. Note: The wheel can be cleaned with water and reinstalled afer drying. Wheel Axle Holder 13