extending multipurpose tray and output bin multipurpose tray The multipurpose paper tray is available as an optional accessory. When the multipurpose tray is installed, it functions as Tray 1. The steps to extend the multipurpose tray are: Open the printer as follows: Pull out the multipurpose tray extension lengthwise until it clicks into place. This extends the multipurpose tray to support media up to A4 length, or 297 mm (11.68 inches). The tray extension also serves as the paper length guide for the multipurpose tray. Pinch and slide the paper width guide to its outermost position. Add paper as follows: The multipurpose tray has a maximum capacity of up to 100 sheets of 75 g/m2 (20 lb.
bond) paper or an equivalent stack height of 10 mm (.39 inch). The print-side of the media must be face-up. For transparencies, the adhesive strip edge must feed into the printer first. To properly align media, place the stack against the left edge of the multipurpose tray (looking from back), and then slide the media down to rest in the tray. Do not overload the tray. Pinch and slide the paper width guide until it fits snugly against the side of media. Gently push down the tray extension until it fits snugly against the top of media. Be careful that the tray extension does not cause the media to bend or sag. Note Configure the paper size for the multipurpose tray.
output bin To extend the output bin for longer media (for example, legal): Grasp the extension on the output bin with one hand on each side. Pull the extension toward you until it does not extend any further. use and maintain hp restricted 3-7