EIO menu 3-36 hp restricted use and maintain CLEAR EVENT LOG N.A. Clears all events listed in the Event Log. This feature can be useful when tracking an issue. TOTAL MONO PAGES 0- 9999999 Tracks the number of pages printed using only black. Default = 9 TOTAL COLOR PAGES 0- 9999999 Tracks the number of pages printed using any color other than black. Default = 9 SERIAL NUMBER N.A. Displays the printer serial number. The serial number displayed in the LCD control panel should match the serial number tag located on the rear of the printer. SERVICE ID N.A. Displays a number for printer administrators to reference when contacting customer support.
COLD RESET PAPER LETTER A4 Resets the default paper size. message value description TCP/IP ENABLE CONFIGURE METHOD MANUAL SETTINGS Enable or disables the TCP/IP menu and set the TCP/IP protocol parameters. In the TCP/IP menu, you can specify BOOTP=YES or DHCP=YES for TCP/IP parameters to be automatically configured by a BootP or DHCP server when the printer is turned on. If you specify BOOTP=NO and DHCP=NO, you can manually set the following TCP/IP parameters from the LCD control panel:
Each byte of the IP address (IP) Subnet Mask (SM) Syslog Server (LG) Default Gateway (GW) Idle Timeout period (default is 270 seconds; 0 disables the timeout) When setting IP numbers, press (up arrow button) to increase the number by 1. Press (select button) to make your selection. IPX/SPX ENABLE FRAME TYPE Enables the IPX/SPX menu, which you can use to set the IPX/SPX protocol parameters. In the IPX/SPX menu, you can specify the frame type parameter used on your network. The default is AUTO, which automatically sets and limits the frame type to the one detected. For Ethernet cards, frame type selections include EN 8023, EN II, EN 8022, and _ _ _ EN SNAP.
For Token Ring cards, frame type _ selections include TR 8022 and TR SNAP. In the _ _ IPX/SPX menu for Token Ring cards, you can also specify NetWareSource Routing parameters, which include SRC RT=AUTO (default), OFF, SINGLE R, or ALL RT. APPLETALK ENABLE Enables or disables the AppleTalk protocol. DLC/LLC ENABLE Enables or disables the DLC/LLC protocol. LINK SPEED LINK SPEED MODE Manually sets the link speed (10 or 100 Mbs) and mode (Full or Half Duplex).