setup & configure hp restricted 2-11 setup procedure steps Unpack the printer and its components Unpack the printer. Remove the packing tape and shipping foam. Two people should lift the printer. Each person should grasp the printer in the front just under the lip below the LCD control panel, and in the rear by the indentation on either side of Tray 1. Alternately, each person can hold on to the bottom of the printer during lifting. It is strongly recommended that two people lift or Warning move the printer. The printer is top-heavy and can tip if lifted by only one person. The side of the printer that holds the ink cartridges and printheads is considerably heavier than the other side.
Do not attempt to move the printer by holding on Warning to Tray 2 in the front or Tray 1 in the back. This can damage the printer and might cause you to lose your grip on the printer. Connect the power cord and turn on the printer Connect the power cord to the printer and an alternating current power outlet. Turn on the printer. Install ink cartridges Lift the ink cartridge cover . Remove each ink cartridge from its package. Align the colored arrows and insert each ink cartridge into its respective color-coded socket. Press in each ink cartridge to ensure proper contact.