Advanced Menu Default Security Menu Default Power (APM) Menu* Default 4 Quiet Boot When enabled, hides summary of power-on self-test and messages during boot. Enabled System Memory Shows the system memory size. 640KB Extended Memory Shows the extended memory size. Detected automatically. Serial port Sets how the serial port is configured by the BIOS (specified or automatic). Enabled Base I/O address Sets the I/O address and interrupt. 3F8 IRQ4 IrDA port Sets how the infrared port is configured by the BIOS (specified or automatic). Disabled Mode When IrDA port is enabled, sets the hardware to support SIR (Standard IR) or FIR (Fast IR) infrared communications.
(Driver installation is required.) SIR Base I/O address When IrDA port is enabled, sets the I/O address and interrupt. 2F8 IRQ3 DMA channel When Fast IR mode is enabled, sets the DMA channel. DMA 3 Parallel Port Sets how the parallel port is configured by the BIOS (specified or automatic). Enabled Mode Sets the port to output only, bi-directional, ECP mode, or EPP mode. Bi-directional Base I/O address Sets the I/O address. 378 IRQ7 DMA channel When ECP mode is enabled, sets the DMA channel. DMA 1 Local Bus IDE Adapter Enables the primary (hard drive) and secondary (CD-ROM drive) controllers. Both Floppy disk controller Enables the floppy disk drive.
Enabled User Password Is Shows if a user password is set. Clear Supervisor Password Is Shows if a supervisor password is set. Clear Set User Password Press ENTER to set, change, or clear user password. Password length can be no longer than 8 characters, 0-9, A-Z. Set Supervisor Password Press ENTER to set, change, or clear supervisor password. This password protects BIOS Setup settings. Password on boot Sets whether a user password is required when the computer boots. Enabled PM Control Disables power management, or enables it Battery Powered