Downloaded from https://www.everyspec.com MIL-STD-31000 5.13 Limited design disclosure models: When a type 3D TDP is required and a subcomponent to the end item does not require complete design disclosure, (such as a commercial item, purchased item, etc.), a 3D model of the subcomponent shall be provided. The subcomponent’s 3D model need not be fully defined, but shall be sufficient to provide adequate visualization, interface characteristics, accurate weight and center of gravity information as required (i.e. cosmetic model) (see para 3.1.20). 5.14 Inspection of TDP.
TDP documents and TDP data management products and the components thereof, including documents prepared by subcontractors, shall be inspected for the following: a. Inclusion of all documents, including sub-tier references, required to meet the information content requirements of the TDP element except those identified in 5.3.2.1. b. Accuracy of the assignment and identification of security markings, restriction statements (for example distribution statements, export control notices, rights-in-data legends, and other special markings.) c. Completeness and accuracy of the TDP documents in describing the design of the item, its subassemblies, and component parts.
The design to be described by the TDP documents is that configuration of the item the Procuring Activity has approved, tested, or accepted. d. Electronic submittals shall open in the appropriate software without regeneration errors. e. The use of National Aerospace Standard NAS 3500 “Technical Data Package: Composition, Communication, and Application” may be used to facilitate the acceptance and inspection of the TDP if required in the contract or purchase order. 15