Downloaded from https://www.everyspec.com MIL-STD-31000B following as a minimum: Nomenclature, Document/Drawing Number, Part Number, Contract Number, Design Activity Identification (e.g. CAGE Code(s)), Approved By, Approved Date, Revision Level Identification, Revision Date, and if applicable Export Control/ITAR Statements, Distribution Statements, Destruction Notices, and/or Classification Requirements,. 5.4.1.2 Developmental engineering design data and associated lists.
When a level (2) developmental TDP is required, developmental engineering design data and associated lists shall be prepared to provide sufficient data to support the analysis of a specific design approach and the fabrication of prototype material for test or experimentation. Data and lists required to present a design approach may vary from simple sketches to complex engineering design data, or may be a combination of both. a. A geometric representation defining the physical shape of the product. b. Definition of dimensions and tolerances defining the item in sufficient detail for engineering analysis and prototype fabrication. c.
Materials, surface finishes, or other manufacturing detail sufficient for engineering analysis and prototype fabrication. d. Sufficient metadata to establish ownership, identification and control, to include the following as a minimum: Nomenclature, Document/Drawing Number, Part Number, Contract Number, Design Activity Identification (e.g. CAGE Code(s)), Approved By, Approved Date, Revision Level Identification, Revision Date, and if applicable Export Control/ITAR Statements, Distribution Statements, Destruction Notices, and/or Classification Requirements. 5.4.1.3 Product engineering design data and associated lists.
When a level (3) Product Level TDP is required, product engineering design data and associated lists shall be prepared to provide the design, engineering, and manufacturing information necessary to enable the procurement or manufacture of an item essentially identical to the original item. The product shall be defined to the extent necessary for a competent manufacturer to produce an item, which duplicates the physical, interface, and functional characteristics of the original product, without additional design engineering effort or recourse to the design activity.
This together with other TDP elements forms a Product Level TDP which will be used to manufacture and support the product throughout its lifecycle. Product engineering data shall reflect the approved, tested and accepted configuration of the defined delivered item and shall consists of the following: a. A geometric representation defining the physical shape of the product. b. Complete definition of dimensions and tolerances defining the item in detail for full rate manufacturing purposes to include appropriate global Geometric Dimensioning and Tolerancing (GD&T) (see ASME Y14.5). c.
Materials, surface finishes, or other engineering and manufacturing detail sufficient for full rate manufacturing. d. All notes, references, or other identifying features necessary to fully define the engineering definition of the item and as necessary for full rate manufacturing. e. Quality assurance information necessary to ensure the item meets its intended performance. 16