HOW TO PERFORM THE TIMER OPERATION SETTING THE TIME SLEEP TIMER MODE Timer operation is performed base on the time set by the steps described in this section. Make sure to set the time to the current time correctly. After certain period has elapsed, the unit stops operating. • Sleep timer The unit stops operating at each setting time once it is set. 1 Press TIMER button. 2 Press button once. Ж 1 Press TIMER button. It enters the timer mode. “Current day of the week” and “Current time” are displayed. 3 Press SET button. [EXAMPLE] “ ” flashes, ” lights. 4 Press or button. The display changes as below. Set as you like. Display area : [ ] [ ] [ ] 7 2 Press SET button. 6 The display area shows :
[ ] ( flashes) [ ] (current time) [ ] 3 Press or button. Align the mark above the day of the week to the current day of the week. 5 Press SET button. Sleep timer has been set. If the Sleep timer is set when the unit stops, it starts operating. After “ ” is displayed in the display area, it returns to step 2 . ” (lights) ” (lights for two seconds) И ” (lights) ” (lights) The time left is displayed by one hour as time passes off after the setting. When the setting time elapses, the unit stops operating. The unit stops operating at each setting time once it is set. 6 Press ON/OFF button. The timer mode is finished. 2 3 1 4 5 6 Press and mark to move to the right and the left respectively.
3•5 2•4 1 If you press the RESET button, the remote control will return to the previous screen and display “ 4 Press SET button. The day of the week is fixed, and the flashing of mark turns to lighting stably. “current time” is displayed by flashing in the ON timer display area, and “ ” is displayed in the display area. • If you press button while timer mode is operative, timer mode is canceled and the display will return to the original display. If you do not press any button for several minutes after entering the timer mode, the timer mode ends and returns to the original display. NOTE OFF TIMER MODE 5 Press or button. Set to the current time. The unit stops operating at the setting time.
This setting is effective for only once. 1 Press TIMER button. 2 Press button twice. [ ] Ж [ ] Ж [ ] 3 Press SET button. [EXAMPLE] “ ” flashes, ” lights. 4 Press or button. Set the time at which you want to stop the operation. If you press the RESET button, the remote controller return to step 1 . 6 Press SET button. The flashing for time display turns to lighting stably, and ” is displayed to show that the current time is set. Two seconds later, it returns to step 1 , and “ ” is displayed. 6 7 Press button. The timer mode is finished. Set “Hour” If you press or button for a while, “Hour” display is changed by one hour, and stops when you stop pressing.
Set “Minute” If you press or button, the display increases or decreases by ten minutes. 5 Press SET button. OFF timer has been set. After “ ” is displayed in the display area, it returns to step 2 . ” (lights) ” (lights for two seconds) ”(lights) ” (lights) The unit stops operating at 6:00 PM. The time display is also turned off. 6 Press button. The timer mode is finished. 3•5 2•4 1 NOTICE If you start the operation while you are setting the OFF timer, operate the air conditioner before setting of timer. ATTENTION If you press button while timer mode is operative, timer mode is canceled and the display will return to the original display.
Note that the setting which has not been completed is canceled. If you do not press any button for several minutes after entering the timer mode, the timer mode ends and returns to the original display. ATTENTION • If you press button while timer mode is operative, timer mode is canceled and the display will return to the original display. If you do not press any button for several minutes after entering the timer mode, the timer mode ends and returns to the original display. 6