After using the appliance Switch off the appliance with the rotary switch. Wait until the blade has come to a standstill. Remove mains plug. Rotate the blender in a clockwise direction and remove. Take the lid off the blender jug. Tip: It is recommended to clean the blender immediately after use. Cleaning and servicing en Risk of burns! Risk of scalding! Caution when processing hot liquids. If processing hot liquids, steam escapes through the funnel in the lid. Add a max. 0,5 litres of hot or frothing liquid. Warning! Process liquids at maximum setting 3. Add a max. 0,5 litres of hot or frothing liquid. Fig. Press release button and move swivel arm into the operating position.
Remove the blender drive cover. Attach blender (mark on the blender holder on mark on the base unit) and turn it all the way anti-clockwise. Add ingredients. – Maximum amount of liquid ingre- dients = 0,75 litres; – Maximum amount of frothing or hot liquids = 0,5 litres; – Optimum processing amount of solid ingredients = 50–100 grams. Observe upper fill mark! Attach the cover. Note position of the seal. Insert the mains plug. Set the rotary switch to the desired setting. Adding more ingredients (Fig. -10) Switch off the appliance with the rotary switch.
Remove the lid and add ingredients or remove the funnel and gradually add solid ingredients through the refill opening or pour liquid ingredients through the funnel. Risk of injury from sharp blades! Do not touch blender blades with bare hands. Clean them with a brush. Taking the blender apart Fig. Turn blender jug clockwise (left-handed thread) and remove it from the blender holder. Take blade insert out of the blender holder. Caution. Risk of injury from sharp blades! Remove seal from the blade insert. Cleaning the blender Warning! Do not clean the blade insert in the dish- washer, but under running water (do not soak in water). Clean blade insert under running water.
To clean thoroughly, the seal can be removed from the lid. Blender holder, seals, lid, funnel and blender jug can be washed in the dishwasher. Tip: After processing liquids, it is often sufficient to clean the blender without removing it from the appliance. Pour a little water and washing-up liquid into the attached blender. Switch on the blender for several seconds (setting M). Pour out the water and rinse out the blender with clear water. Important information When processing liquids/liquid ingre- dients, slowly increase the speed of the appliance in stages to prevent the food from shooting out. Operate appliance at maximum setting 3. Robert Bosch Hausgerдte GmbH 7