Before using the appliance en 4.4 Overload protection 2. Take hold of the required cutting disc by the edge and fit onto the disc holder with the side you re- quire facing up. The overload protection system pre- vents the motor and other compon- ents from being damaged through being overloaded. If the continuous feed shredder is overloaded or blocked, the disc holder shaft will break at the prede- termined breaking point. Note: Spare parts with a predeter- mined breaking point are not covered by our warranty obligations. A new disc holder is available from cus- tomer service under order number 00630760. ‒ Fit single-sided discs with the blades or serrations facing up.
‒ Fit reversible discs with the re- quired marking facing up. → Fig. 5 3. Insert the disc holder with the cut- ting disc into the housing. → Fig. 6 4. Place the lid on the housing. → Fig. 7 Markings and must match up. 5. Rotate the lid clockwise until it en- Before using the appliance 5 Before using the appli- gages. → Fig. 8 Markings and must match up. ance Before using the appliance Prepare the base unit and the ac- cessories for use. 5.3 Fitting continuous feed shredder onto the base unit 5.1 Overview of base units You can prepare your kitchen ma- chine as shown. → Fig. 3 1. Place the continuous feed shred- der on drive 2 as shown. → Fig. 9 2.
Push the continuous feed shredder MUM5 series MUMS2 series down and rotate clockwise until it engages. → Fig. 10 The continuous feed shredder must be securely connected to the base unit. 5.2 Assembling the continu- ous feed shredder 1. Grip the disc holder level with the wings. → Fig. 4 The two plastic tips must point up. Basic operation 6 Basic operation Basic operation 6.1 Processing food with the continuous feed shredder Note: Take note of the recommended speeds. → "Application examples", Page 21 19 A Food processor from the B Food processor from the