4 Screen Creation 4-4 Screen Creation This part describes how to create screens displayed on NB7W. [1 Wait] [1 Wait] is the first display screen in the garage door control system. The screen will be displayed with the lower limit LS ON. Configure functions below: • Level Meter component, indicating numbers of headlights flashing detected by the sensors in forms of graphics. 4-4 Screen Creation • Bit Button components, allocated to [Open], [Stop] and [Close] garage door operations respectively. • Bit Button component, for accessing the maintenance screen. The component turns ON when the button is pressed for 3 seconds. The whole screen is shown below.
The following objects must be created and configured: a b 4 [Open] Use the vector graphic: Up.vg Address: W_bit 1.00 c [Stop] Use the vector graphic: Middle.vg Address: W_bit 1.01 d [Close] Use the vector graphic: Down.vg Address: W_bit 1.02 a Screen b Bit Button components c Texts d Level Meter component z Screen Start the following procedures after the NB7W operation is set. 1 Select [Add Screen] from the toolbar. Input “Wait” at the screen name area. The initial design screen No. is 0, named “Frame0”, when user added a new frame, the screen No. start from 10 by default. Frame 1 to 9 are default frames for the system. NB-series Programmable Terminals Startup Guide Manual(V109) 4-13