No. 600 Prices Pounds Sterling Carriage Extra Issued December 2002 Section 4 Tooling 14 Series 10 Series 7 254 Part No. Description Price Excl. VAT £ Price Incl. VAT £ 1429 Taper turning attachment, arranged for bolting on to a machined facing at the back of the bed.The holes for the securing screws are so arranged that the attachment can be used along any portion of the bed. Angular movement is 10° either side of zero.
The slide base is 228mm (9) long giving a working length for taper turning of 150mm (6) 272.21 319.84 95/094 Taper turning attachment, arranged for bolting on to a machined facing at the back of the bed.The holes for the securing screws are so arranged that the attachment can be used along any portion of the bed. Angular movement is 10° either side of zero. The slide base is 358mm (14) long giving a working length for taper turning of 253mm (915/16) 389.29 457.41 1483 Multi-stop, for use with No. 1408 turret attachment is bolted on to the back of the bed, and to the saddle, beneath the rear strip.
Six length stops are provided which can prove a useful facility for normal turning independent of the turret. Maximum stroke 114mm (41/2), stop screw adjustment 50mm (2) 206.22 242.30 95/133 Longitudinal multi-stop, bolted on to the back of the bed, and to the rear face of the saddle. Six length stops are provided, which can prove a useful facility for turning and milling to dead stops. Maximum stroke 114mm (41/2), stop screw adjustment 50mm (2) 294.90 346.50 95/129 Cross slide multi-stop, bolted on to the rear of the saddle and cross slide. Five length stops provide a useful facility for turning pre-set diameters to dead stops.
Stop block assembly can be fitted to any of four rearmost tee slots. Stop screw adjustment 50mm (2) 243.08 285.61 Note: On the 254 stops must only be used when working with the feed shaft (with overload clutch). Never use stops when working with leadscrew nut engaged.