Differences Between NJ/NX and NX Stand a lone Creating a New Project When creating a new project, under “Select Device” section, for category select “Slave Terminal”. Verify “EtherNet/IP Coupler” automatically appears for “Device”. Online Difference #1 No choice with communication type (Ethernet or USB) when going online. Difference #2 No way to go online from menu bar of the coupler. (However, really easy to log on from the menu bar of the Safety CPU.) Only able to go online with the USB cable. CPU Pulldown List The CPU listed in the pull down box is “new_SlaveTerminal_0.” Hardware Configuration New naming is EtherNet/IP and it automatically has the coupler.
The toolbox does not list couplers. It only shows the NX-SL3300 V1.1. (No NX-SL3500) It will automatically select the SIH400 V1.1 module. QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 23 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com