Convert NJ/NX Program to NX Stand a lone December 2014, Sysmac Studio version 1.11 Hardware Replace the coupler, NX CPU and SIH400 input modules. Open up a new project 1.) This is available with Sysmac Studio version 1.10 and higher. (Released Sept. 2014) Category: Slave Terminal Device: EtherNet/IP Coupler Hardware set-up without actual hardware 1.) Use schematics or take a snap shot of the original equipment. If you have multiple screens, you can open Sysmac Studios up for both projects. 2.) In this case, the SIH400 safety input module is version 1.0. The Safety stand-alone CPU requires at least a 1.1 version SIH400 module. This will need to be upgraded. (To change:
right click on module -> change model -> select the new model -> ok) Node Configuration 3.) From the CPU drop down list, select “new_SafetyCPU0” QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 3 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com