Assign Variables Location on Standard Side 20.) Multiview Explorer -> Configurations and Setup -> Communications -> Standard -> Standard I/O 21.) Manually assign the device and linked port. (Hint: If you have multiple screens with a copy of the original and new programs open, look at the I/O map of the original program. NJ controller -> Configurations and Setup -> I/O Map) I/O Map 22.) Multiview explorer -> Configurations and Setup -> I/O Map Notice: Depending on the versions of NX CPUs you were using, the comments from the original NJ/NX program may be ones that were manually created. The NX Stand a lone program will reuse the comments created in the nodes in the I/O map.
NJ/NX NX Stand a lone 23.) Most efficient way to enter the variable names is to use the pull down list. Cut and Pasting the entire list did not transfer all of them correctly. QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 5 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com