29.) In the NX Stand a lone program, open up the program, click on the left column to highlight the line, right click and paste. Scroll down to the bottom and delete the last line if it is empty. 30.) Repeat these steps for all of the programs. Build 31.) Project -> Build controller Download 1.) Go Online. 2.) Select “new_SlaveTerminal_0” (or the name it was changed to for the coupler )from the device pulldown menu. 3.) Configurations and Setup -> EtherNet/IP -> NX-EIC202 4.) Double click on NX-EIC202 QSG-NX-S-STANDALONE - Version 3.2 Feb. 27, 2015 Page 7 OMRON AUTOMATION & SAFETY • © 2015 Omron Electronics LLC • www.omron247.com