Introduction Install EmbeddedView or CEView on a target device Install EmbeddedView on a Windows Embedded Standard computer, or install CEView on a Windows Embedded Compact device, to use it as a project runtime server and/or client. You must have already installed the full InduSoft Web Studio software on your computer, either from the installation disc or from the downloadable installer, because the redistributable EmbeddedView and CEView software is included in the InduSoft Web Studio program folder. To install and run EmbeddedView or CEView, you must have: • A Windows Embedded-compatible computer or device (a.k.a.
the target device); • A Windows Embedded Standard or Windows Embedded Compact operating system that is currently supported by Microsoft, which at this time includes: • Microsoft Windows XP Embedded Service Pack 3 • Microsoft Windows Embedded Standard 7 • Microsoft Windows Mobile or Windows CE 5.x/6.x • Microsoft Windows Embedded Compact 7 • 100 MB of free hard drive space or non-volatile memory (flash card or hard disk) for the runtime. More space might be required depending on your project size. • 32 MB of free RAM. More memory might be required depending on your project size. • An Ethernet or Wi-Fi network adapter, for TCP/IP networking. The following items are optional but recommended:
• A USB port; and • Serial COM ports and adapters, to be used for direct communication with PLCs and other devices. This is optional because many newer device protocols use TCP/IP communication instead of serial communication. Installing EmbeddedView or CEView on a target device is actually a two- part procedure. First, you will copy the Remote Agent utility to the target device and then run it. Remote Agent allows you to connect from the project development application to the target device. And second, through Page 22