Introduction this connection, you will install the rest of the EmbeddedView or CEView software. Note: If EmbeddedView or CEView is pre-installed on the target device, you may skip this entire task. Many hardware manufacturers pre-install Remote Agent on their devices, as part of a larger InduSoft Web Studio package. To install EmbeddedView or CEView: 1. Turn on the target device and make sure it is connected to your TCP/IP network. If Remote Agent is pre-installed on the target device, it will automatically run at start up, and you may skip the next step. Many hardware manufacturers pre-install Remote Agent on their devices, as part of a larger InduSoft Web Studio package. 2.
Copy the Remote Agent utility to the target device and then run it: a) Locate the correct version of the Remote Agent utility ( CEServer.exe ) for the target device. All versions are stored in your InduSoft Web Studio program folder. Remote Agent for Windows Embedded Standard is located at: C:\Program Files\InduSoft Web Studio v7.1\Redist \WinEmbedded\Bin\CEServer.exe Remote Agent for Windows Embedded Compact is located at: C:\Program Files\InduSoft Web Studio v7.1\Redist\WinCE 5.0\ processor \Bin\CEServer.exe …where processor is the specific processor used by the target device. For more information, consult the manufacturer's documentation.
b) Copy CEServer.exe to the target device by either downloading it over the network, transferring it on a USB flash drive, or syncing it with Microsoft ActiveSync. (ActiveSync is also known as Windows Mobile Device Center in Windows Vista or Zune Software in Windows 7.) You may save the file anywhere you want on the target device, as long as it is in permanent (i.e., non-volatile) memory and it is not in the root folder (i.e., C:\ or \). c) Set Remote Agent to automatically run at start up. Page 23