1. Connection Procedure for Remote Access 6. Connection Procedure for Remote Access This section describes the procedures for remote access from Sysmac Studio on a personal computer to the Controller in a remote location via the internet. The procedures for setting up the Controller and the SiteManager in this guide are based on the factory default settings. Refer to Section 7 Initialization Method for information on how to initialize the Controller and the SiteManager. Take the following steps to remotely access from Sysmac Studio on your personal computer to the Controller in a remote location. Log in to the GateManager. ↓ 6.2.1.
Internet Connection of the Connect your personal computer to the internet. Personal Computer ↓ 6.2.2. Password Setting for the Log in to the GateManager as an administrator and set a password. GateManager Administrator ↓ 6.2.3. Creation of LinkManager User Create a LinkManager user account for GateManager login. Account ↓ Set up the SiteManager. ↓ 6.3.1. Hardware Settings Make the hardware settings for the SiteManager and connect the cables. ↓ Access from your personal computer to the SiteManager. 6.3.2. Access to the SiteManager ↓ 6.3.3. Connection Settings with the Make the settings for the SiteManager to connect to the GateManager. GateManager ↓ 6.3.4.
Connection with the Connect the SiteManager to the internet and establish a connection with the GateManager. GateManager ↓ 6.3.5. Connection Settings with the Set the IP address of DEV ports on the SiteManager. Controller ↓ 6.3.6. Agent Setup for the Controller Configure an agent for the target device (Controller) which is connected to the SiteManager. Startup Guide – Remote Access - RT1 Series - P151-E1-02 11 6.1. Work Flow 6.2. GateManager Setup 6.3. SiteManager Setup