7 ． EtherNet/IP Connection Procedure 7.2.2. IP Address Settings Set the IP address of Robot Controller. The IP Addresses are set using ACE. Install ACE on Personal computer beforehand. For information on how to install the software, refer to the ACE User's Guide, v3.4.x (Cat. No. I603-E). Since the Personal computer and Robot Controller are connected via Ethernet, set the IP address of Personal computer to 172.16.127.10 . Precautions for Correct Use The Parameters for Robot Controller are checked using the Ethernet communications with Personal computer. Note that there may be some changes required for the Personal computer settings depending on the state of Personal computer.
1 Turn ON Personal computer, Switching hub, and Robot Controller. 16