Let’s Get Started 1 Put the earphones into the charging cradle. R The LED (light blue) flashes once on each side. (Put the earphones into the charging cradle again if the LED does not flash.) R Charging time (the time from empty to full charge) EAH-AZ80/EAH-AZ60M2/EAH-AZ40M2 You can charge the earphones with the charging cradle if it is sufficiently charged, even when there is no power supply nearby. 1 Put the earphones into the charging cradle. R The earphone status indicator LED quickly flashes red (twice). (Put the earphones into the charging cradle again if the LED does not flash.) R The earphone status indicator LED lights up (red), and charging starts.
R Charging is complete when the earphone status indicator LED turns off. R Charging time (the time from empty to full charge) Note: R If the charging cradle is fully charged, you can charge earphones with no charge about two times. Charge wirelessly (EAH-AZ100/EAH-AZ80/EAH-AZ60M2) You can charge this unit with a separately sold Qi standard wireless charger. For information about your wireless charger, please refer to its manual. 1 Close the charging cradle lid. 2 Place the charging cradle on the wireless charger with the Technics logo facing up. R Qi charging contact position EAH-AZ100: Qi charging contact Page 15 EAH-AZ80: Qi charging contact Page 17 EAH-AZ60M2:
Qi charging contact Page 19 Important: R The unit is not guaranteed to charge with all commercially available Qi standard wireless chargers. R This unit does not support wireless chargers that are not Qi standard certified or have magnetic attachments. Do not use these chargers to charge the charging cradle. (It may cause the charging cradle to malfunction.) R Do not charge wirelessly in the following places. In humid, dusty, or shaky areas, or near telephones, TVs, radios, or devices with built-in magnets R Before charging wirelessly: Remove any covers attached to the charging cradle. 27 Charging only the earphones About 2.0 hours Charging only the earphones About 2.0 hours