FAQ 4 When you hear the pairing sound (melody) from earphone (R), release your finger from touch sensor (R). R To listen to the pairing sound, click {{"Here"|tolink("https://eww.pavc.panasonic.co.jp/ avcacc/technics/sound-data/Pair_const.wav")}}. R If you do not hear the pairing sound even after touching for about 10 seconds, start over from step 1. 5 Touch and hold touch sensor (R) again until you hear the completion message. R Resetting earphone (R) is complete when you hear the completion message. 6 Put earphone (R) back into the charging cradle. 7 Repeat steps 2 to 6 above for earphone (L). Note:
R To pair a Bluetooth ® device with the earphones again, delete the pairing information (device name) on the Bluetooth ® device that was paired with the earphones, and then pair the earphones with the Bluetooth ® device again. “Use the app to pair with a Bluetooth ® device”, Page 34 “Pair with a Bluetooth ® device without the app”, Page 35 R Some settings such as the language settings for voice prompt and Amazon Alexa are not reset. R You can use the [Technics Audio Connect] app to reset to the factory settings (default settings upon purchase). “Reset the headphones to factory settings”, Page 63 Maintenance Maintenance R Wipe with a soft, dry cloth.
R Remove the earpieces from the earphones and remove any earwax or dust. (Do not touch the protective mesh because it affects the audio characteristics.) The illustrations use EAH-AZ60M2 as an example. For the EAH-AZ100 “Removing the earpiece”, Page 32 1 2 76